UZIN HS 200 Premium Plus - Tile & Stone Waterproof Membrane

High performance cement based waterproofing membrane

Data sheet

UZIN HS 200 is a flexible one-component, cement-based waterproofing membrane for tile and stone in interior, exterior, commercial, residential, and immersion applications. Used as a crack-isolation membrane, UZIN HS 200 also reduces crack transmission in tile and stone floors.

Applications

Over properly prepared concrete, masonry, cement mortar beds, and leveling coat
Over tile industry recommended backer boards
Over gypsum wallboard (interior)
Over industry-standard plywood (interior, dry conditions)
Over radiant heated substrates
Over UZIN brand surface preparation products where applicable
For use in showers, bathrooms, nursing homes, hotels, kitchens, laundry rooms, pools, spas, walkways, pool decks, balconies, building facades, fountains
For use in steam rooms or steam showers when used in conjunction with a vapor barrier (perm rating 0.1 or less ASTM E-96 Procedure A)
For contact with Schluter® Kerdi, Kerdi Drain, and other Schluter® components
For immersion and exterior applications, excellent freeze-thaw, aging, and fatigue resistance
To prevent in-plane floor cracks from transmitting through tile or stone

Properties

One-component - No latex admix needed
Fine textured raw materials - Smooth application
Tested and approved - Validated performance and peace of mind
No mesh required to meet ANSI A118.10 - Easier application & reduced potential of weak points
Variable water ratio - Control viscosity to preferred workability
Hybrid-set speed - Good working time, yet same-day tile installation
Light color - Easy to see reference lines

UZIN_PDS_HS 200_24-06_June-28 2 MB
Safety Data Sheet - UZIN HS200 - EN 211 KB
VOC Certificate SCS-IAQ-08156 279 KB
Surface Preparation Recommendations 205 KB
HS_100-HS_200_UZIN_Certificate_IAPMO_2024 393 KB

* At 70 °F (21 °C) and 65 % relative humidity. Temperature, conditions and surface porosity will affect dry time.
Packaging	27.5 lb (12.5 kg) paper bag
Storage	minimum 12 months
Layer thickness	40 mil (1 mm) double coat thickness build 20 mil (.5 mm)
Mixing ratio	3.7 – 4.8 quarts (3.5 – 4.5 liters) per 27.5 lb (12.5 kg) bag For partial bags mix at 3 parts powder to 1 part water
Color	Light grey
Coverage	80 – 90 sq. ft. (7.0 – 8.0 m²) @ two 20 mil coats (.5 mm)
VOC	0 g/L
Application temperature	40 – 95 °F (5 – 30 °C)
Drying time	Approx. 48 hrs.
Working time	approximately 1 hour^*
Setting time / cure time	1st coat 2 hours^* - 2nd coat 5 hours^*
Storage	minimum 12 months